Alarm Control System
Access Control System
Photoelectric Beam Sensor

Electro Magnetic Locks
Models&Descriptions

 

 

BS-200RC/BS-400RC/BS-600RC/BS-800RC
Barrier- Curtain Sensor
Features
Aluminum housing; PC cover as UV lights filter; ABS side caps
Slim/stylish aluminum housing, anti high/low temp./fog/rains.
Sensing range: 8 meters (outdoors)
Tx power adjustment: Normal/Strong
Response time adjustable (50/100/150/200 msec adjustable)
Built in flexible flat cable as the bridge between beams and beams instead of hard PCB.
Built in optical lens. (Longer sensing range)
Smart infrared receiver module, free from any disturbance by external remote controllers.
Anti-tamper circuit triggers alarm if power is cut or end cap is removed.
Alarm: Break one or two adjacent beams.
L-brackets and mounting hardware included.
IP-65 water/dust proof.

Specifications
Model

BS-200RC

BS-400RC
BS-600RC
BS-800RC
Number of Beams
2
4
6
8
Dimensions(mm)

35¡Ñ30¡Ñ570

35¡Ñ30¡Ñ1050
35¡Ñ30¡Ñ1530
35¡Ñ30¡Ñ2010
Range

8 meters (25 feet) max.-outdoor / 16 meters (50 feet) max.-indoor

Operating Voltage
10 ~ 30 VDC
Detection method

Break one beam or two adjacent beams
(1) 1 beam: 2 seconds alarm
(2) 2 adjacent beams: immediately
***1 beam broken alarm trigger function can be removed;
See (JP2) which located at Rx's side cap;
(JP2) Jumper closed: 1 beam broken alarm (2 sec.) function existed.
(JP2) Jumper opened: 1 beam broken alarm (2 sec.) function removed.

Signal output Normal open / Normal close / Common relay output
Response Time (Rx) 50/100/150/200 ms (selectable - by SW1 slide switch-Rx)
Contact rating 1A/120VAC ; 1A/24VDC
Tx Power Adjustment (by VR1) (a) when turn clockwise: become stronger
(b) when turn counter-clockwise: become normal
Power Led indicator Green Led (On both Tx/Rx unit) ¡@On : powered¡@Off : no power
Led indicator
for Beam alignment		 Red Led (On Rx unit)
On : when beam is broken ; Off : when beam is aligned properly
Buzzer Alarm
(for beam alignment)
Black jumper1(JP1)(ON Rx)unit		 (a)On : when sensor is connected with DC power & before beam
alignment is done.
(b)Off : when beam aligned properly ; automatically.
***This function can be cancelled by JP1 removed***
Tamper Switch 4 pcs/each set ; 2 on both sides of Tx/2 on both side of Rx
Operating temp -25¢J~55¢J (-13¢K~131¢K)
Dimensions

W: 35 mm / H: 30 mm / L: see following
Humidity

70%